This is the mail archive of the crossgcc@cygnus.com mailing list for the crossgcc project.
| Index Nav: | [Date Index] [Subject Index] [Author Index] [Thread Index] | |
|---|---|---|
| Message Nav: | [Date Prev] [Date Next] | [Thread Prev] [Thread Next] |
PPCBUG is one of the supported ROM monitors in the PowerPC version of gdb. It's built in to gdb, you don't have to do anything special to use it. Just enter the gdb command 'target ppcbug <port>', where <port> is the name of the serial port that is connected to the Power PC board. Scott Robert J. Brown wrote: > > I am working on a project using a MCP750 Compact PCI board. This > board has a JTAG/BDM capability, but only to the extent that there are > pads on the artwork; there are no pins soldered into the pads. This > is apparently because they would stick up and interefere with the > memory card that sits piggyback on the board. We were planning to use > the SDS Single Step BDM debugger, but I do not think that will work > now, due to the mechanical fit problem. > > I heard somewhere that there is an extension to gdb that allows gdb to > gain control of the board by sending and receiving PPCbug commands > instead of using the remote gdb support code in the target. This > would be great. Does anyone know abything about this? > > -- > -------- "And there came a writing to him from Elijah" [2Ch 21:12] -------- > R. J. Brown III rj@elilabs.com http://www.elilabs.com/~rj voice 847 543-4060 > Elijah Laboratories Inc. 457 Signal Lane, Grayslake IL 60030 fax 847 543-4061 > ----- M o d e l i n g t h e M e t h o d s o f t h e M i n d ------ > _______________________________________________ > New CrossGCC FAQ: http://www.objsw.com/CrossGCC > _______________________________________________ > To remove yourself from the crossgcc list, send > mail to crossgcc-request@cygnus.com with the > text 'unsubscribe' (without the quotes) in the > body of the message. _______________________________________________ New CrossGCC FAQ: http://www.objsw.com/CrossGCC _______________________________________________ To remove yourself from the crossgcc list, send mail to crossgcc-request@cygnus.com with the text 'unsubscribe' (without the quotes) in the body of the message.