Re: ICD BDM, gdb, and error 613 on 68331

["Aaron J. Grier" <aaron at frye dot com>]

On Thu, Nov 11, 1999 at 04:38:33PM -0500, Quality Quorum wrote:

> I am using it. I have heavily modified original Gunter Magin's
> patches.  I am using gdb 4.17 to control 68360. I can dig my patches
> if necessary, however, I suspect it may be something else:

This would be very useful...

> It is quite possible that your stuff is actually working fine and the
> problem is that you did not initialize all necessary (and there are a
> lot of them)peripheral registers corectly.

Ay, here lies the rub.  I can't even touch the peripheral registers out
of a cold boot -- as soon as I touch them, I get stuck in the "error
613" loop.  Performing the exact same initialization sequence under
ICD32 under DOS works just fine.

-- 
  Aaron J. Grier   |   Frye Electronics, Tigard, OR   |   aaron@frye.com
  "The simplistic anthropomorphism which asserts that source code has a
   life separate from its creator or maintainer is the product of one
   too many viewings of Tron."  -- paraphrasing of anonymous post on /.

------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sourceware.cygnus.com