This is the mail archive of the crossgcc@sources.redhat.com mailing list for the crossgcc project.

See the CrossGCC FAQ for lots more information.

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]
Other format:	[Raw text]

Re: Cross Tools Help

From: "Aaron J. Grier" <aaron at frye dot com>
To: crossgcc at sources dot redhat dot com
Date: Tue, 6 May 2003 11:21:35 -0700
Subject: Re: Cross Tools Help
References: <20030307085116.A12967@saturn.billgatliff.com> <Pine.SV4.3.93.1030505121132.21934A-100000@eid>

On Mon, May 05, 2003 at 12:14:01PM -0500, sridhar wrote:
> Dear Mr.Gatliff,
> 
> 	When i build a m68k-elf cross tool chain, during configure step i
> specify target=m68k-elf and the toolset is built for all families of m68k
> like CPU's 68K, 68020, 68030, 68040, etc.
> 
> 	If i want to build the toolset for a particular CPU only (say
> 68020), how do i do it?

in gcc source code, look in config/m68k/t-m68kelf at the MULTILIB_*
lines and adjust as desired.

-- 
  Aaron J. Grier  |   Frye Electronics, Tigard, OR   |  aaron@frye.com

------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sources.redhat.com

References:
- Re: Cross Tools Help
  - From: sridhar

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]