Re: newbie questions remain regarding crosstool with an arm920t target (arm_920TDI)

["Wolcott, Ken (MED, Compuware)" <Ken dot Wolcott at med dot ge dot com>]

Hi Dan;

  Thank you.  I have posted to the arm list, will probably post the gcc list.

Ken

On Friday 17 October 2003 14:27, Dan Kegel wrote:
> Wolcott, Ken (MED, Compuware) wrote:
> >   Changing "920t" to "arm920t" in arm920.dat unfortunately did not solve
> > the problem as the following excerpt from demo.sh shows.  Looking at the
> > arm regular expressions shows that I can only specify an arm9 or an
> > arm9tdmi target rather than an arm920t.  Do I need to get a patch from
> > somewhere?  I know I don't have the nomenclature down pat yet, but I
> > think I was told that arm9 instruction set might work ok for this board. 
> > This I have to confirm.
>
> I'm afraid arm is not my specialty.  You'll have to do a little
> research and/or ask the arm experts...
>
> Glad I was able to help up to this point, at least!
> - Dan

-- 
Kenneth A. Wolcott
Consultant, Clinical Systems Engineering
GE Medical Systems Information Technologies
8200 West Tower Avenue, Milwaukee, WI  53223
Phone:  414/362-2720 
Email:  Ken.Wolcott@med.ge.com

------
Want more information?  See the CrossGCC FAQ, http://www.objsw.com/CrossGCC/
Want to unsubscribe? Send a note to crossgcc-unsubscribe@sources.redhat.com