Re: verify NEON support in cross toolchain

[Dwi Sasongko Supriyadi <ruckuus at gmail dot com>]

On Mon, Feb 28, 2011 at 6:08 AM, Michael J. Hammel
<crosstoolng@graphics-muse.org> wrote:
> I'm using Crosstool-NG 1.8.2 to get a cross toolchain for a BeagleBoard.
> I'm trying to verify the NEON support. ?I've enabled the following two
> configuration options:
>
> CT_ARCH_FPU="neon"
> CT_CC_CORE_EXTRA_CONFIG="--with-fpu=neon"
>
> However, when I try to build the xorg omap driver I get the following
> error:
>
> CC sw-exa.lo
> {standard input}: Assembler messages:
> {standard input}:105: Error: bad instruction `vld1.u8 {d0},[r1]!'
> {standard input}:108: Error: bad instruction `vld1.u8 {d1},[r4]!'
> {standard input}:109: Error: bad instruction `vld1.u8 {q1},[r7]!'
> {standard input}:110: Error: bad instruction `vzip.u8 d0,d1'
> {standard input}:111: Error: bad instruction `vld1.u8 {q2},[r6]!'
> {standard input}:112: Error: bad instruction `vst2.u8 {q0,q1},[r5]!'
> {standard input}:113: Error: bad instruction `vmov.u8 q1,q2'
> {standard input}:114: Error: bad instruction `vst2.u8 {q0,q1},[sl]!'
> make[5]: *** [image-format-conversions.lo] Error 1
>
> I think this means that neon is not enabled, but I can't be sure yet.
>
> Is there some test I can run to check if the neon support is correctly
> turned on? ?The complete config file is on my site:
> http://www.graphics-muse.org/source/xcc/xcc.cfg.1.8.2
>
> Thanks.

Probably this doesn't help but you can see the output of readelf

readelf -a file.o | grep VFP

--
For unsubscribe information see http://sourceware.org/lists.html#faq