RE: toolchain for s390 using older kernal headers

[Azeem Ahmed <AAhmed at rocketsoftware dot com>]

Thank you Yann. 

I was able to build what I needed using a higher level of kernel but specifying the correct "minimum supported kernel version" for the glibc options. 

Thanks,
Azeem 

-----Original Message-----
From: Yann E. MORIN [mailto:yann.morin.1998@free.fr] 
Sent: Sunday, July 22, 2012 9:22 AM
To: crossgcc@sourceware.org
Cc: Azeem Ahmed
Subject: Re: toolchain for s390 using older kernal headers

Azeem, All,

On Thursday 05 July 2012 18:00:01 Azeem Ahmed wrote:
> I am attempting to use crosstool-NG to build a toolchain for the following setup: 
> Kernel: 2.6.16 (to support SLES 10 SP1)

linux-2.6.16 is too old: it does not properly export its headers.
You need *at the very least* a 2.6.18.

Regards,
Yann E. MORIN.

-- 
.-----------------.--------------------.------------------.--------------------.
|  Yann E. MORIN  | Real-Time Embedded | /"\ ASCII RIBBON | Erics' conspiracy: |
| +33 662 376 056 | Software  Designer | \ / CAMPAIGN     |  ___               |
| +33 223 225 172 `------------.-------:  X  AGAINST      |  \e/  There is no  |
| http://ymorin.is-a-geek.org/ | _/*\_ | / \ HTML MAIL    |   v   conspiracy.  |
'------------------------------^-------^------------------^--------------------'

--
For unsubscribe information see http://sourceware.org/lists.html#faq