This is the mail archive of the
cygwin-xfree
mailing list for the Cygwin XFree86 project.
Re: "No absolute path for shell:" error
- From: "Larry Hall (Cygwin X)" <reply-to-list-only-lh-x at cygwin dot com>
- To: cygwin-xfree at cygwin dot com
- Date: Wed, 30 Nov 2005 19:34:15 -0500
- Subject: Re: "No absolute path for shell:" error
- References: <0IQS00MMNIL21R@mailhost.uark.edu>
- Reply-to: cygwin-xfree at cygwin dot com
- Reply-to: cygwin-xfree at cygwin dot com
On 11/30/2005, Douglas Spearot wrote:
Thank you for the response Thomas. I downloaded the source from the website
that you listed below. When I try to run the 'configure' file that you
created to build XTERM, I get a number of error messages (all of which say
the same thing): "The procedure entry point getline could not be located in
the dynamic link library cygwin1.dll"
Make sure you have one and only one cygwin1.dll on your system. If you do,
make sure you've rebooted after the last install you did (from setup.exe).
This is a classic message that occurs when you're running apps that expect
a more current cygwin1.dll than can be found/loaded into memory.
--
Larry Hall http://www.rfk.com
RFK Partners, Inc. (508) 893-9779 - RFK Office
838 Washington Street (508) 893-9889 - FAX
Holliston, MA 01746
--
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
Problem reports: http://cygwin.com/problems.html
Documentation: http://x.cygwin.com/docs/
FAQ: http://x.cygwin.com/docs/faq/