This is the mail archive of the cygwin@sourceware.cygnus.com mailing list for the Cygwin project.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]

RE: problems w/ cygwin-1.1.2


> Hi,
>    I am trying to use cygwin-1.1.2 on NT SP3. I went
> thru the installation process (via setup etc). The
> installation process goes thru without any problems.
> However, when I try to use any program from the bin
> dir (even ls) it takes an awfully long time to finish.
> Even "ls" seems to take atleast a few seconds (upto 10
> secs at times) to finish. Similar times are observed
> w/ running bash. It seems that the time delay is quite
> independent of the program being run -- something that
> makes me suspect the cygwin.dll. Needless to say, this
> has prevented me from using this version. I had
> experienced similar problems w/ cygwin-1.1.1. I have
> found that my 1.5 yr old Cywgin-B20 works "normally".
>
>
> (Please note that I DON'T have two versions of cygwin
> on my computer -- I went thru the painful process of
> installing the new version (over the modem), only to
> uninstall it and install my old version back)
>
> Could anyone please shed light on this? It will be
> quite good to move to the latest cygwin release.

Try the uname -a command and check that it says 1.1.2 in the version part. When I
had this problem I discovered that the setup had not copied the new cygwin1.dll
file to the right place!

Regards,
Tony.
--
Tony Arnold, Science and Engineering Support Unit, University of Manchester.
Tel: +44 (161) 275 6093, Fax: +44 (161) 275 6071,
E-mail: tony.arnold@man.ac.uk, Web: http://www.man.ac.uk/Tony.Arnold


--
Want to unsubscribe from this list?
Send a message to cygwin-unsubscribe@sourceware.cygnus.com


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]