This is the mail archive of the
mailing list for the Cygwin project.
Re: Programming problem with POSIX threads and stdout
Thanks, Brian! Actually, I had seen that posting, but I missed the fact that
the third reply was from Faylor, and not from the original poster, who said
that the problem had been fixed *after* the last stable release.
I'll go get a recent snapshot of the DLL.
Thank you again,
----- Original Message -----
From: "Brian Ford" <firstname.lastname@example.org>
To: "Mauro Brunato" <email@example.com>
Sent: Wednesday, September 29, 2004 6:09 PM
Subject: Re: Programming problem with POSIX threads and stdout
On Wed, 29 Sep 2004, Mauro Brunato wrote:
The following has probably already been noticed by someone,
but I could not find any reference (at least, comprehensible to me), so
I apologize if my problem has already been taken care of.
How 'bout this thread?:
Consider the following code:
I also tried putting debug or optimization flags (-g, -O, -O2) and put an
explicit "-lpthread" at the end, with no luck.
-lpthread is not needed on Cygwin. The pthreads code is part of the
Senior Realtime Software Engineer
VITAL - Visual Simulation Systems
the best safety device in any aircraft is a well-trained pilot...
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
Problem reports: http://cygwin.com/problems.html