This is the mail archive of the
cygwin
mailing list for the Cygwin project.
Re: problem while connecting GDB to an ARM board
- From: Larry Hall <lh-no-personal-replies-please at cygwin dot com>
- To: Michael LUITAUD <michael dot luitaud at st dot com>, cygwin at cygwin dot com
- Date: Thu, 04 Aug 2005 16:35:27 -0400
- Subject: Re: problem while connecting GDB to an ARM board
- References: <42F22995.2040400@st.com>
- Reply-to: Cygwin List <cygwin at cygwin dot com>
At 10:43 AM 8/4/2005, you wrote:
>I used to use linux to compile code for my ARM based board but I needed windows and cygwin 1.5.8 to connect to the platform and debug via the ARM Multi-ICE Server and the Multi-ICE gdb Server.
>I now have to stop using linux so, I installed the GNUARM Tool Chain for Cygwin. That Tool Chain needs 1.5.18 version of cygwin1.dll to work because it needs the _impure_ptr procedure.
_impure_ptr has been a part of Cygwin symbols for a long time now. This is
not new with 1.5.18. Perhaps you meant some specific element referenced
through _impure_ptr? In any case, 1.5.18 is the version this list
recommends you run with when using Cygwin.
>I thaught it was right but I can not connect to the platform anymore and get "putpkt: write failed: Software caused connection abort" error on trying to connect.
This is really a better question for the GNUARM folks. I'm not sure there
are allot of GNUARM Tool Chain users subscribed to this list.
--
Larry Hall http://www.rfk.com
RFK Partners, Inc. (508) 893-9779 - RFK Office
838 Washington Street (508) 893-9889 - FAX
Holliston, MA 01746
--
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
Problem reports: http://cygwin.com/problems.html
Documentation: http://cygwin.com/docs.html
FAQ: http://cygwin.com/faq/