This is the mail archive of the
mailing list for the Cygwin project.
Re: cygwin out of sync with version?
That indeed did solve my problem. I did a quick glance in the direction
over at cygwin.com but did not see a specific reference to the recent
bash release. Do you have a link I could read?
Larry Hall (Cygwin) wrote:
Joey Officer wrote:
I have a script that I run, the script is:
for i in $( ls *.gz ); do
echo Searching $i
zcat -c $i | grep $1 >> searchresults.txt
echo Finsihed searching $i , moving on to the next
Now, this used to work just fine, but now I receive the following
$ ./findme.bash 10.65.118.
'/findme.bash: line 2: syntax error near unexpected token `do
'/findme.bash: line 2: ` for i in $( ls *.gz ); do
The only thing that I can think of that might have changed was that I
recently downloaded and installed the mjpegtools for cygwin, which
might have been compiled under a different version of cygwin,
earlier/devel? ... at anyrate, I've run this same script on another
linux box for testing, and it still works just fine, which is why I'm
back to thinking that this is a problem with my install of cygwin.
Is there a way to repair the existing installation, or a way to
confirm that all of the installed software is the correct version?
I've already run the setup, and had it perform the updates that were
available, but it still is erroring out.
Read the announcement for the recent release of bash and run your script
through 'd2u'. The former should familiarize you with the basis for this
issue and possible solutions in general and the latter will fix your
current problem. ;-)
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple
Problem reports: http://cygwin.com/problems.html