This is the mail archive of the
mailing list for the Cygwin project.
Re: Rebaseall fails with error 6 on cygcrypt-0.dll
-----BEGIN PGP SIGNED MESSAGE-----
Alex Leigh wrote, On 4.7.2010 9:20:
> On Sun, Jul 4, 2010 at 1:07 AM, Larry Hall (Cygwin) wrote:
>> On 7/4/2010 1:01 AM, Alex Leigh wrote:
>>> I've been getting some STATUS_ACCESS_VIOLATION errors when running
>>> bash and some xwin programs, and after some searching I'm trying to
>>> run rebaseall to see if that would fix the problem. However, when
>>> running rebaseall from ash, I get the following error: "ReBaseImage
>>> (/usr/bin/cygcrypt-0.dll) failed with last error = 6". Searching
>>> around it seems error code 6 comes from the DLL being in use. However
>>> I made sure to close all running cygwin programs, and I went through
>>> each of my running programs to see if any of them loads that
>>> particular DLL, which none of them do. Could there be anything else
>>> that would cause rebaseall to fail on that particular DLL? Thanks.
>>> I've attached an output from cygcheck.
>> Make sure you stopped all services and then reboot.
> I rebooted, then shut down all non-essential programs and services,
> and still get the same error. This is baffling...is there anything
> else that could cause this error?
Download the Process Explorer and find out who is holding the file open.
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.10 (MingW32)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/
-----END PGP SIGNATURE-----
Problem reports: http://cygwin.com/problems.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple