This is the mail archive of the
mailing list for the Cygwin project.
Re: Rebaseall fails with error 6 on cygcrypt-0.dll
On 7/4/2010 3:20 AM, Alex Leigh wrote:
On Sun, Jul 4, 2010 at 1:07 AM, Larry Hall (Cygwin) wrote:
On 7/4/2010 1:01 AM, Alex Leigh wrote:
I've been getting some STATUS_ACCESS_VIOLATION errors when running
bash and some xwin programs, and after some searching I'm trying to
run rebaseall to see if that would fix the problem. However, when
running rebaseall from ash, I get the following error: "ReBaseImage
(/usr/bin/cygcrypt-0.dll) failed with last error = 6". Searching
around it seems error code 6 comes from the DLL being in use. However
I made sure to close all running cygwin programs, and I went through
each of my running programs to see if any of them loads that
particular DLL, which none of them do. Could there be anything else
that would cause rebaseall to fail on that particular DLL? Thanks.
I've attached an output from cygcheck.
Make sure you stopped all services and then reboot.
I rebooted, then shut down all non-essential programs and services,
and still get the same error. This is baffling...is there anything
else that could cause this error?
Something has that DLL open/locked. I suppose it doesn't have to be
Cygwin but I wouldn't know what that would be. Any rogue cygwin1.dlls
on your system.
To be sure you've excluded all things Cygwin from this install, do a
'cygrunsrv --list' followed by a 'cygrunsrv --stop <service_name>'
where <service_name> is any service you see listed by the previous
Larry Hall http://www.rfk.com
RFK Partners, Inc. (508) 893-9779 - RFK Office
216 Dalton Rd. (508) 893-9889 - FAX
Holliston, MA 01746
Q: Are you sure?
A: Because it reverses the logical flow of conversation.
Q: Why is top posting annoying in email?
Problem reports: http://cygwin.com/problems.html
Unsubscribe info: http://cygwin.com/ml/#unsubscribe-simple