This is the mail archive of the ecos-discuss@sourceware.cygnus.com mailing list for the eCos project.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]

Port to uCsimm (uC68EZ328)?



Is anybody working on a port to the uCsimm?  It's basically a Motorola
68EZ328 dragonball with some dram, flash, and 10baseT enet controller
in a 30 pin simm form factor.  It was designed to run Linux.  See
www.uclinux.com for info.

I am using it for a robot controller, but I'm coming to the realization
that Linux is just too big for what I want to do.  It's hard to get
good timing for motor control, etc, from it when running Linux.  So
I'm going to take a whack at porting eCos to it, but before I get too
far I wanted to see if anyone else is working on any ports to it,
or at least any 68k ports.

Thanks,
	-Matt


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]