This is the mail archive of the
ecos-discuss@sourceware.cygnus.com
mailing list for the eCos project.
Re: BreakPoint problems !!
- To: "P.Mahendra Babu" <babu at cdotb dot ernet dot in>
- Subject: Re: [ECOS] BreakPoint problems !!
- From: Jesper Skov <jskov at redhat dot com>
- Date: 23 Feb 2000 14:27:03 +0100
- Cc: eCos-Discuss Mailing List <ecos-discuss at sourceware dot cygnus dot com>
- References: <Pine.OSF.4.21.0002231708210.28237-100000@jnana.cdotb.ernet.in>
>>>>> "P" == P Mahendra Babu <babu@cdotb.ernet.in> writes:
P> Hello Everybody, =09 =09We have downloaded ecos-SW tools for Linux
P> and =09installed the tools for target powerpc-eabi. =09We use
P> MBX860 board and have successfully fused =09stubrom for startup.
P> =09Now, when we make programs, we are successfully =09able to
P> download and run them. We are able to =09set more than one
P> breakpoints but, only the =09first one is hit. After the first
P> breakpoint is =09hit, there is no control... i.e., it doesn't stop
P> =09in further breakpoints. Even step, next commands =09do not seem
P> to work. Program just continues until =09exit point irrespective of
P> the command given(step, =09next or continue..) What is the problem
P> ? =09Does anybody else have the same problem ? Or the =09gdb stubs
P> can handle only one breakpoint now ? =09When I list the
P> breakpoints using "maintenance =09info breakpoints", all
P> breakpoints are alive even =09after the first breakpoint is hit.
P> =09Hope to receive a solution faaaaaaaaast.
Two suggestions:
1) Get the latest sources from CVS. In those the ROM stub support is
a bit better than it was before.
2) (the faaaaastest fix) enable stubs in your ecos configuration.
Jesper