This is the mail archive of the ecos-discuss@sourceware.cygnus.com mailing list for the eCos project.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]

[Fwd: MBX]


[ Forwarded since this guy is spam-blocked ]


I sent this to you before, but I had the wrong address, so I'm resending...

I am kinda confused now.  What I did was just remove the directories built
from the configuration tool and resave the same configuration I setup for my
board (40 MHz clock).  After I recompiled and downloaded the stub it started
to work as I expected.  It's odd because I didn't change anything.  Could it
be that something didn't get compiled the first time correctly or maybe it
didn't download into flash correctly?

However, now it seems that when I try to run one of the example programs
using insight 5.0 (with the patch installed) the code will download but it
crashes quite a bit.  The target will just stop communicating with insight. 
This makes it difficult to debug since I have to cycle power on the MBX
board and re-download the code each time.

Is this flaky behavior typical of the MBX board - do you guys experience
similar problems or are your platforms more robust?

Thanks,
Anthony



Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]