This is the mail archive of the
ecos-discuss@sourceware.cygnus.com
mailing list for the eCos project.
Re: insight/gdb/linux
- To: alexs at redhat dot com
- Subject: Re: [ECOS] insight/gdb/linux
- From: Jonathan Larmour <jlarmour at redhat dot co dot uk>
- Date: Tue, 20 Jun 2000 15:28:43 +0100
- CC: ecos-discuss at sourceware dot cygnus dot com
- Organization: Red Hat UK Ltd.
- References: <NCBBKJPHEKGAJNNFGNBLCEKKFCAA.alexs@redhat.com>
Alex Schuilenburg wrote:
>
> > > [deleted]
> > > > Is there some way to get insight to just start/continue
> > > > what's already down there?
> > >
> > > Once you have loaded the code on the target, use the gdb console command
> > > "cont". The problem w/ insight is that it uses "run" which is
> > incompatible
> > > with the way eCos stubs works.
> >
> > Why do you think this is the case? For a remote target, insight uses
> > continue, as you would expect.
>
> Not the last time I tried. Hitting the run button just issued "run", even
> for remote targets. I always had to get up a console to kick start the
> session. After that everything was OK.
With Insight 5.0?
Jifl
--
Red Hat, 35 Cambridge Place, Cambridge, UK. CB2 1NS Tel: +44 (1223) 728762
"Plan to be spontaneous tomorrow." || These opinions are all my own fault