Re: [ECOS] build Tx39xx program

["adon at walkersun" <adon at walkersun dot com>]

Hi all,


    Maybe I have to change the question that is, what are the cygmon could
do for me??? Does the program just serve for downloading program from the
host to the target, so I should link another cygmon program into my program,
and after I do that so, I could debug my program at my target???

    Sorry, for eCos system, I am a beginer, so I have some question maybe
looks stupid, but I have done another system over cygmon, but that could
debug and ineteract with me. So I think I lack something over this
system(eCos). I prepare to develop a system with eCos, but there are
something miss with me so I cannot start my project. Are there anybody could
tell me??

Adon Chen



----- Original Message -----
From: "Jonathan Larmour" <jlarmour@redhat.com>
To: "adon@walkersun" <adon@walkersun.com>
Cc: <ecos-discuss@sourceware.cygnus.com>
Sent: Monday, September 04, 2000 9:20 PM
Subject: Re: [ECOS] build Tx39xx program


> > "adon@walkersun" wrote:
> > The crt0.o, crtbegin.o and the libraries files like libc.a libgcc.a
> > libjmr3904.a libdve.a, jmr3904.ld are come while I build the tool chain.
> >
> >  While I use the libjmr3904.a the linker always prompt me "connot find
> > label get_mem_info",[snip]
>
> This doesn't have anything to do with eCos. Perhaps Toshiba recommend some
> other place for support?
>
> Out of interest, I noticed that in some mips-tx39-elf tools I found here,
> get_mem_info was defined in libtx39jmr.a, but this may be a different
> version to what you have. You would need to contact Toshiba (or someone
> else who provides support for these tools) to get an answer appropriate to
> the tools you have.
>
> Jifl
> --
> Red Hat, 35 Cambridge Place, Cambridge, UK. CB2 1NS  Tel: +44 (1223)
728762
> "Plan to be spontaneous tomorrow."  ||  These opinions are all my own
fault
>
>
>