RE: [ECOS] help on aeb-1

["Robert Cragie" <rcc at jennic dot com>]

> Hi,
>     i am using AEB-1evaluation board..
> How do i download the ecos gdb stub for arm aeb-1 to the flash..
> i am using hyperterminal to connect to board..
>
> The steps which i followed
>
> 1. new connection->aeb
> 2. baud rate->9600
>     flowcontrol->none
> 3.ARM Evaluation Board Boot Monitor 0.01 (19 APR 1998)
> 	Press ENTER within 2 seconds to stop autoboot
>
> Press ENTER quickly, and you will get the boot prompt:
>
> 	Boot:download c000
> Ready to download. Use 'transmit' option on terminal emulator to download
> file.
>
> then i selected the transfer receive file menu and tried to download
> /loaders/aeb-1/gdb_module.img.UU

I have not used the AEB-1, but I have successfully downloaded to the ARM
Integrator using its boot monitor.

1) You may need an S-record file not a .img file. 'objdump' can be used to
get an S-record file from a .img file.
2) .UU on the end - could this be uuencoding? You certainly don't want that
either.
3) You may need to enable XON/XOFF flow control in Hyperterminal

HTH

Robert Cragie
Design Engineer
Jennic Ltd.
Furnival Street
Sheffield
S1 4QT
United Kingdom
Tel: +44 (0) 114 281 4512
Fax: +44 (0) 114 281 2951
mailto:rcc@jennic.com
http://www.jennic.com


>
> connection timed out..
>
> Can someone help on this
>
> regards,
> mekala
>
>
>
> This e-mail and any files transmitted with it are for the sole
> use of the intended recipient(s) and may contain confidential and
> privileged information.
> If you are not the intended recipient, please contact the sender
> by reply e-mail and destroy all copies of the original message.
> Any unauthorised review, use, disclosure, dissemination,
> forwarding, printing or copying of this email or any action taken
> in reliance on this e-mail is strictly
> prohibited and may be unlawful.
>
> 		Visit us at http://www.cognizant.com
>