Re: [ECOS] How to run eCos in SMDK41100 board

["james chen" <james_ch1 at sina dot com>]

Thank you for your reply. now I have another question. I have installed
linux(RedHat7) and gcc version is 2.96, now I can use it to compile Linux
synthetic target, can I use this gcc to compile arm based CPU( for example
ARM7)? or I should have another( arm-elf-gcc), if then where can I get it?

Thanks

James Chen

> james chen wrote:
> >
> > Now I have a SMDK41100 board (Samsung
> > MCU Development Kit) based on S3C44B0X (CPU is ARM7TDMI), I don't know
how
> > to let eCos run on it. the SMDK41100 board doesn't have eth net, can I
run
> > RedBoot through serial port and how to do it?
>
> Yes RedBoot can be used over serial. To port a new board, generally the
> advice is to copy an existing port that is closest to what you have. In
> your case, the PID may be a good start. Then adapt it bit by bit for your
> board.
>
> See http://sources.redhat.com/ecos/docs-latest/porting/index.html for some
> more detail.
>
> Jifl
> --
> Red Hat, Rustat House, Clifton Road, Cambridge, UK. Tel: +44 (1223) 271062
> Maybe this world is another planet's Hell -Aldous Huxley || Opinions==mine
>