This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
StrongARM SA1110
- To: ecos-discuss at sources dot redhat dot com
- Subject: [ECOS] StrongARM SA1110
- From: Warren Jasper <warrenj at tx dot ncsu dot edu>
- Date: Mon, 05 Mar 2001 09:12:01 -0500
- Organization: NCSU
--
I am trying to port eCos to a development board which uses the
Intel StrongARM SA1110. I have 2 questions.
1. In your instructions for the tools set, is the default
Little Endian or Big Endian. Is there a way to tell if
the cross compiler is configured one way or the other by default?
I know about the -EB and -EL flags. The cross compiler is
called arm-elf-gcc
2. I configured eCos for the target assabet, which appears to the
the correct target for the StrongARM SA 1110. Since the StrongARM
is basically a SOC, a general Boot ROM Monitor should get me
started. I have 4 MB of Flash Boot ROM on the board.
What is the exact name of the file that I should use to load into
FLASH? If one is precompiled, is it for Big or Little Endian?
Thanks,
-- Warren
Warren J. Jasper
wjasper@tx.ncsu.edu