[ECOS] AW: able to boot i386 from floppy with ecos

[Hansjörg Petriffer <hpetriffer at grips dot com>]

Hello,

You have to select in i386architecture->i386 Pc target->diagnostic output
options  output to pc-screen then you see the output on the screen. 

If you select Floppy as startup type and make than the test programs, you
can use the i386-elf-objcopy -O xxx.exe xxx.bin command than you could use
this binary to make a startdisk. 

Regards

Hansjoerg

-----Ursprüngliche Nachricht-----
Von: sasi [mailto:vsasikanth@usa.net]
Gesendet: Mittwoch, 28. März 2001 17:00
An: Jonathan Larmour
Betreff: able to boot i386 from floppy with ecos


dear jonathan,

thank you sir.

we are able to boot the target and run hello world sample program.

sir, should we load all the remaining tests to run our applications, since
some of the tests are not running.

how to run our own applications ?

on target monitor some codes are being displayed, can't we see what is
internaly being done or hello world printed on screen instead of on the
ouput
tab in tools->run tests.


please guide me to run the applications.

thanking you
sasi