This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
eCos -Jeeni compatibility.
- From: "rudra Chaudhury" <rudra_c at hotmail dot com>
- To: ecos-discuss at sources dot redhat dot com
- Date: Tue, 27 Nov 2001 21:10:09 +0530
- Subject: [ECOS] eCos -Jeeni compatibility.
- Bcc:
I am using Cirrus logic EP7211 board and eCos as my RTOS. Using gdb I am
able to download code onto my board and execute without using Jeeni, i.e.
without any hardware debugger support.
When I use Jeeni as between the board and gdb then also I am able to
download the program. The problem is that I am unable to step in( which is
possible if I do not use Jeeni), however I am able to put breakpoints and
able to proceed step by step(i.e. I can do the "next" operation). When I try
to step inside, instead of going inside the control goes to the next line of
the code.
for example if I have a sample code:
1. main()
2. {
3. func_abc();
4. func_def();
5. }
6.
7. func_abc()
8. {
9. pqr();
10. }
when I am in line 3 and request for a step in then instead of going to line
8 it goes to line 4.
I suspect that I need to do some configuration to Jeeni.
On receiving the Jeeni I configured it using:
ejconfig -com1 -i 10.0.0.42 -s 255.255.255.0 -g 10.0.0.5 -c ARM7TDI
Do I need to do some other configurations as well.
Thanks in advance for any help on this topic
regards
--Rudra
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp