This is the mail archive of the
ecos-discuss@sources.redhat.com
mailing list for the eCos project.
Debugging eCos using Insight/RedBoot over network
- From: "Peter Dennett" <pdennett at padsoft dot com>
- To: <ecos-discuss at sources dot redhat dot com>
- Date: Sat, 28 Sep 2002 19:31:48 -0500
- Subject: [ECOS] Debugging eCos using Insight/RedBoot over network
- Organization: PADSOFT, Inc
- Reply-to: "Peter Dennett" <pdennett at padsoft dot com>
I am just starting with eCos and RedBoot so
I have some newbie questions.
I have an Cirrus 7212 on a edb7111-2 board.
I am working with sources pulled from CVS
27-Sep-02.
I have installed the pre-built RedHat RedBoot
image on the board. I used fconfig to turn
off DHCP and configured a static IP.
(1) I can build TwoThreads.c using the eCos
libraries produced by the "default" template,
download, and debug. It seems to run fine.
If I build eCos libraries using any "network" template
(I think configured to the same static IP) I lose
my debug session early on in start up.
Any guidance on how to debug over the
same net you are trying to operate on?
(2) I dont seem to be able to build my own
RedBoot. I saw some notes in the archives
from about a year ago and followed these
but no joy. Seems pretty simple, select
the target, select the RedBoot template,
add some packages, set ROM execution,
build.
When I do this I dont see any traffic
on the serial port as seen with the
prebuilt one.
Any hints here?
TIA
Peter Dennett Email: pdennett@padsoft.com
61 Harbor Lane Web: www.padsoft.com
Kemah, TX 77565 Web: www.boatbrains.com
Voice: 281 334 3800 Cell: 713 899 6100
--
Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
and search the list archive: http://sources.redhat.com/ml/ecos-discuss