Re: [ECOS] synthetic target

[Stefano Martini <martini at sci dot univr dot it>]

Thanks,

but I don't know how to start the auxilary user interface.
How can I do?.


On Wed, 2003-07-30 at 10:46, Andrew Lunn wrote:
> > When the ecos application starts I can see on the screen
> > all the information of the eth0 device that are ok, but the
> > connect fails. The rawether is not running and if I try to
> > start it manually it sets up the tap1 device (not tap0 as
> > it is configured).
> 
> You cannot start rawether manually. It uses pipes to communicate with
> the auxiliary so only the auxiliary can start it.
> 
> OK. Back to basics. Any of the following could be happening:
> 
> 1) The auxiliary could not be starting... Assuming you don't pass -nw,
>    do you get the auxilary windows, as shown at
> 
>    http://sources.redhat.com/ecos/docs-latest/ref/synth-gui.html
> 
> 2) The auxiliary cannot find rawether so cannot start it.
> 
> 3) The auxilary starts rawether, but it exists because of some error
>    condition. eg cannot open the device etc.
> 
> I don't have a working setup in front of me at the moment, but i
> expect there should be some clues in the main window of the
> auxiliary. Does it mention trying to load the ethernet device? Are
> there any error message at all? 
> 
>       Andrew
> 
> -- 
> Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
> and search the list archive: http://sources.redhat.com/ml/ecos-discuss
> 



-- 
Before posting, please read the FAQ: http://sources.redhat.com/fom/ecos
and search the list archive: http://sources.redhat.com/ml/ecos-discuss