This is the mail archive of the ecos-discuss@sources.redhat.com mailing list for the eCos project.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]
Other format: [Raw text]

Redboot run problem on Malta-4kc


hi, everyone

I'm trying to load redboot rom mode to Mips Malta-4kc board. 
When this is complete, the LED display should show the last address 

programmed. This will be something like: 1fc17000. But the display didn't 

show address but just "dl_done".

then i reset the target, the display can show "RedBoot", but on the 

minicom, it shows the following:

+IDE failed to identify unit 0 - wrote: a0, read: 0
IDE failed to identify unit 0 - wrote: b0, read: 0
IDE failed to identify unit 1 - wrote: a0, read: 0
IDE failed to identify unit 1 - wrote: b0, read: 0
FLASH configuration checksum error or invalid key

if i reset the board again, the messege will be shown again. Any input 

cause no reponse. How could be that? Is there any configuration problem?

Any suggestions? thanks a lot.



-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]