This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
Re: Problem reading buttons on AT91sam7s-ek
> > // Enable the clock to the GPIO (enable input sampling)
> > HAL_WRITE_UINT32(AT91_PMC + AT91_PMC_PCER, AT91_PMC_PCER_PIOA);
>
> You only need to enable the clock once. You could move this outside of
> the read function.
Ok thanks again, will do that. I also plan to convert my example to a
macro, to save the overhead of making the function call.
>
> Maybe i should add a macro to var_io.h to enable/disable the clock?
That might be a good idea, or add a comment to
HAL_ARM_AT91_GPIO_CFG_DIRECTION
and
HAL_ARM_AT91_GPIO_GET
stating that the clock must be enabled to receive inputs. At least it
was not obvios to me, and others might benefit too :-)
By the way can you point me to an example/documentation of how to use
HAL_ARM_AT91_GPIO_CFG_INTERRUPT
I want to setup the buttons to generate interupts for handling user input.
I have found some domentation of how to set up ISR and DSR using
cyg_interrupt_create().
However, I can figure out how to map a GPIO pin to trigger the interrupt vector?
Cheers
Rasmus
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss