This is the mail archive of the
ecos-discuss@sourceware.org
mailing list for the eCos project.
Re: which address of FLASH should at91sam7s redboot burn to ?
Typically ROM startup is used for building RedBoot.
make sure you startup is ROM.
wb ning wrote:
>
> hello, everyone, i downloaded the Prebuilt RedBoot binaries for Atmel
> AT91SAM7S. But After i burn the redboot_rom.bin into at91sam7s256's
> flash at address 0x100000, it can't startup when power on. The
> datasheet said 0x100000 is the beginning address of Flash. So i burn
> it there. I use the readelf command to find the redboot_rom.elf say
> its entry point is 0x100040, But when i burn redboot_rom.bin there, it
> can't startup either. Can you tell me where should i burn the
> redboot_rom.bin, since the redboot_rom.elf is too large to burn.
> Thanks.
>
> --
> Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
> and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss
>
>
>
--
View this message in context: http://www.nabble.com/which-address-of-FLASH-should-at91sam7s-redboot-burn-to---tp24087199p24105870.html
Sent from the Sourceware - ecos-discuss mailing list archive at Nabble.com.
--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss