Re: [ECOS] printf/gets/etc not working

[Slide <slide dot o dot mix at gmail dot com>]

On Mon, Aug 16, 2010 at 10:43 AM, Ilija Kocho <ilijak@siva.com.mk> wrote:
> On 16.08.2010 19:00, Slide wrote:
>> On Sat, Aug 14, 2010 at 8:51 AM, Ilija Kocho <ilijak@siva.com.mk> wrote:
>>
>>> On 14.08.2010 16:00, Slide wrote:
>>>
>>>> On Sat, Aug 14, 2010 at 3:44 AM, Ilija Kocho <ilijak@siva.com.mk> wrote:
>>>>
>>>>
>>>>> Check if hardware serial ports (such as /dev/ser0) and TTY-mode devices
>>>>> (such as /dev/tty0) are included.
>>>>> In configtool:
>>>>> ? ?I/O sub-system -> Serial device drivers +-> Hardware serial device
>>>>> drivers
>>>>> ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?+-> TTY-mode serial device
>>>>> drivers
>>>>> // Ilija
>>>>>
>>>>>
>>>>>
>>>> I do have TTY-mode devices enabled, but I thought that if I enabled
>>>> tty0 it would conflict with the ttydiag or the haldiag devices that
>>>> seem to be created.
>>>>
>>>>
>>> In addition you can avoid usage of haldiag (ttydiag) device by setting
>>> "Console device name" to "/dev/tty0".
>>>
>>>> Thanks,
>>>>
>>>>
>>
>> I did what you suggested, and enabled TTY port 0 and disabled the TTY
>> diagnostic device.
>
> Did you set "Console device name" to /dev/tty0?
>
>> I see the following printed out when the target
>> boots:
>>
>> Init device '/dev/tty0'
>> Init tty channel: 0x8010f590
>> Init device '/dev/haldiag'
>>
>> Which is good, no more ttydiag, but printf still doesn't work. Is
>> there anything I can do to test if tty0 is working? I set my default
>> console device name in the ISO C package and in the TTY area.
>>
>> Thanks,
>>
>> slide
>>
>>


Yes, under I/O sub-system > Serial device drivers > TTY-mode serial
device drivers I set "Console device name" to "/dev/tty0", I also set
ISO C Library > ISO C library standard input/output functions >
Default console device to "/dev/tty0"

thanks,

slide

--
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss