This is the mail archive of the ecos-patches@sourceware.org mailing list for the eCos project.

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]
Other format:	[Raw text]

Re: USB serial package

From: Andrew Lunn <andrew at lunn dot ch>
To: Frank Pagliughi <fpagliughi at mindspring dot com>
Cc: ecos-patches at sourceware dot org
Date: Fri, 6 Jun 2008 09:33:10 +0200
Subject: Re: USB serial package
References: <48489207.1090301@mindspring.com>

> I tested this with the AT91SAM7S-EK board as the device target, but it  
> should work with any USB-enabled eCos board.

Hi Frank

Thanks for the code. I will take a look at it over the weekend.

You said in a previous email that the AT91 USB driver was broken, its
state transition indications pass the wrong values. Do you have a fix
for that? Does this serial driver depend on the fix?

    Thanks
        Andrew

Follow-Ups:
- Re: USB serial package
  - From: Frank Pagliughi

References:
- USB serial package
  - From: Frank Pagliughi

Index Nav:	[Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav:	[Date Prev] [Date Next]	[Thread Prev] [Thread Next]