This is the mail archive of the
gdb-patches@sourceware.org
mailing list for the GDB project.
gdb.base/dump.exp: Force the correct endianness
- From: "Maciej W. Rozycki" <macro at mips dot com>
- To: gdb-patches at sourceware dot org
- Cc: "Maciej W. Rozycki" <macro at linux-mips dot org>
- Date: Tue, 24 Jul 2007 17:40:35 +0100 (BST)
- Subject: gdb.base/dump.exp: Force the correct endianness
Hello,
Testcases in gdb.base/dump.exp use binary formats that do not carry
endianness information. This causes failures if gdb supports both
endiannesses, but the original binary used by the script is of the
non-default one.
The following fix has been successfully tested for mipsisa32-sde-elf,
with the mips-sim-sde32/-EB and mips-sim-sde32/-EL target boards. Gdb
defaults to the big endianness in this configuration, so with the latter
board dumps of arrays from SREC and hex formats are currently seen
endian-reversed.
2007-07-24 Maciej W. Rozycki <macro@mips.com>
* gdb.base/dump.exp: Force the correct endianness for binary
formats not carrying this information.
OK to apply?
Maciej
gdb-dump-endian.diff
Index: gdb/src/gdb/testsuite/gdb.base/dump.exp
===================================================================
--- gdb.orig/src/gdb/testsuite/gdb.base/dump.exp 2007-01-09 17:59:11.000000000 +0000
+++ gdb/src/gdb/testsuite/gdb.base/dump.exp 2007-07-24 17:25:17.000000000 +0100
@@ -34,6 +34,7 @@
set options {debug}
set is64bitonly "no"
+set endian "auto"
if [istarget "alpha*-*-*"] then {
# SREC etc cannot handle 64-bit addresses. Force the test
@@ -70,6 +71,19 @@
return -1
}
+# Get the endianness for the later use with endianless formats.
+
+send_gdb "show endian\n"
+gdb_expect {
+ -re ".* (big|little) endian.*$gdb_prompt $" {
+ set endian $expect_out(1,string)
+ pass "endianness: $endian"
+ }
+ default {
+ fail "(timeout) getting target endianness"
+ }
+}
+
# Now generate some dump files.
proc make_dump_file { command msg } {
@@ -190,6 +204,18 @@
gdb_start
gdb_file_cmd ${binfile}
+# Now fix the endianness at the correct state.
+
+send_gdb "set endian $endian\n"
+gdb_expect {
+ -re ".* (big|little) endian.*$gdb_prompt $" {
+ pass "setting $endian endianness"
+ }
+ default {
+ fail "(timeout) setting $endian endianness"
+ }
+}
+
# Reload saved values one by one, and compare.
if { ![string compare $array_val \