This is the mail archive of the gdb-patches@sourceware.org mailing list for the GDB project.


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]
Other format: [Raw text]

Re: [PATCH] GDB/testsuite: Correct gdb.base/watchpoint-solib.exp timeout tweak


On 07/29/2014 01:10 PM, Maciej W. Rozycki wrote:
> Hi,
> 
>  Similarly to the changes to gdb.reverse/sigall-reverse.exp and 
> gdb.reverse/until-precsave.exp recently posted this corrects the timeout 
> tweak in gdb.base/watchpoint-solib.exp.
> 
>  This test case executes a large amount of code with a software watchpoint 
> enabled.  This means single-stepping all the way through and takes a lot 
> of time, e.g. for an ARMv7 Panda board and a `-march=armv5te' multilib:
> 
> PASS: gdb.base/watchpoint-solib.exp: continue to foo again
> elapsed: 714
> 
> for the same board and a `-mthumb -march=armv5te' multilib:
> 
> PASS: gdb.base/watchpoint-solib.exp: continue to foo again
> elapsed: 1275
> 
> and for QEMU in the system emulation mode and a `-march=armv4t'
> multilib:
> 
> PASS: gdb.base/watchpoint-solib.exp: continue to foo again
> elapsed: 115
> 
> (values in seconds) -- all of which having the default timeout of 60s, set 
> based on the requirement of the remaining test cases (other than 
> gdb.reverse ones).
> 
>  Here again the timeout extension to have a meaning should be calculated 
> by scaling rather than using an arbitrary constant, and a larger factor of 
> 30 will do, leaving some margin.  Hopefully for everyone or otherwise 
> we'll probably have to come up with a smarter solution.
> 
>  OTOH the other test cases in this script do not require the extension so 
> they can be moved outside its umbrella so as to avoid unnecessary delays 
> if something goes wrong and a genuine timeout triggers.
> 
>  Tested on arm-linux-gnueabi.  OK to apply?

OK

> +
> +set savedtimeout $timeout
> +if { [target_info exists gdb,timeout]
> +     && $timeout < [target_info gdb,timeout] } {
> +    set oldtimeout [target_info gdb,timeout]
> +} else {
> +    set oldtimeout $timeout
> +}
> +set timeout [expr $oldtimeout * 30]

Clearly this pattern is going to be popping in more
places going forward.  Maybe we should even consider factoring
it out to a with_test_prefix-like procedure.  Something like:

 proc with_timeout_factor { factor } {
   ...
 }

 with_timeout_factor 30 {
    ...
    gdb_test "continue" ".*Breakpoint 2.*foo.*" "continue to foo again"
    ...
 }

Thanks,
Pedro Alves


Index Nav: [Date Index] [Subject Index] [Author Index] [Thread Index]
Message Nav: [Date Prev] [Date Next] [Thread Prev] [Thread Next]