This is the mail archive of the
gdb-patches@sourceware.org
mailing list for the GDB project.
Re: [PATCH 1/8] Set signal to 0 after enqueue_pending_signal
- From: Yao Qi <qiyaoltc at gmail dot com>
- To: Pedro Alves <palves at redhat dot com>
- Cc: Yao Qi <qiyaoltc at gmail dot com>, gdb-patches at sourceware dot org
- Date: Fri, 18 Mar 2016 14:36:38 +0000
- Subject: Re: [PATCH 1/8] Set signal to 0 after enqueue_pending_signal
- Authentication-results: sourceware.org; auth=none
- References: <1457088276-1170-1-git-send-email-yao dot qi at linaro dot org> <1457088276-1170-2-git-send-email-yao dot qi at linaro dot org> <56E2A3B3 dot 8010303 at redhat dot com>
Pedro Alves <palves@redhat.com> writes:
>> gdb/gdbserver:
>>
>> 2016-03-04 Yao Qi <yao.qi@linaro.org>
>>
>> * linux-low.c (linux_resume_one_lwp_throw): Set 'signal' to
>> 0 if signal is enqueued. Remove 'signal' from one debugging
>> message. Move one debugging message to some lines below.
>> Remove code setting 'signal' to 0.
>
> OK.
Patch is pushed in.
--
Yao (éå)