This is the mail archive of the
gdb-prs@sourceware.org
mailing list for the GDB project.
Re: gdb/2426: Temporary breakpoint for "finish" command not cleaned up in MI mode
- From: Nick Roberts <nickrob at snap dot net dot nz>
- To: nobody at sources dot redhat dot com
- Cc: gdb-prs at sources dot redhat dot com,
- Date: 6 Mar 2008 19:48:01 -0000
- Subject: Re: gdb/2426: Temporary breakpoint for "finish" command not cleaned up in MI mode
- Reply-to: Nick Roberts <nickrob at snap dot net dot nz>
The following reply was made to PR gdb/2426; it has been noted by GNATS.
From: Nick Roberts <nickrob@snap.net.nz>
To: tom.fowler@hotmail.co.uk
Cc: gdb-gnats@sources.redhat.com
Subject: Re: gdb/2426: Temporary breakpoint for "finish" command not cleaned up in MI mode
Date: Fri, 7 Mar 2008 08:43:19 +1300
> The "finish" command appears to work by setting a temporary breakpoint which
> is deleted immediately after it is triggered. Using my version of GDB in
> normal console mode this works as expected, but using the same executable in
> "--interpreter=mi" mode, the "finish" command leaves its breakpoint around
> to fire spuriously later on. Having looked into this a little, it seems to
> be a regression, in that the problem does not occur for an earlier version
> of GDB (v 6.0.x).
Looks like it's fixed in GDB in the Sourceware CVS repository. If you can't
get this, GDB 6.8 should be released very shortly.
--
Nick http://www.inet.net.nz/~nickrob