This is the mail archive of the
gdb@sources.redhat.com
mailing list for the GDB project.
Re: Thread-specific breakpoints
On Mon, Aug 16, 2004 at 04:20:39PM +0200, Fabian Cenedese wrote:
> Yes, that's along the lines I was thinking. And after intense looking I even
> found it in the manual. I missed it the first time as the break command
> is explained in 5.1.1 whereas break <location> thread <number> by itself
> is in 5.4.
>
> After looking at the communication with the stub it seems that the Z0
> packet only informs the stub about a breakpoint but not about the thread.
> So every thread will stop here and gdb needs to tell them to continue
> it it's not the wanted one. That could generate quite a lot of communication
> (important if it's a serial connection) and also changes the timing quite
> a lot. If the breakpoint handling was in the stub the stop'n'go could be
> made much faster without the interaction of gdb. I guess if there is no
> other possibility I could use the "monitor" command to inform the stub
> about the thread of the breakpoint. But then again this is difficult as the
> breakpoints are only set once a "step" or "continue" is sent...
>
> Thanks for the help anyway
Yes, there's no way to set remote-assisted thread-specific breakpoints
in the remote protocol. This might be a good thing to add.
--
Daniel Jacobowitz