This is the mail archive of the
gdb@sources.redhat.com
mailing list for the GDB project.
RE: Can't talk to Angel debug monitor from arm-elf-gdb
- From: "Dave Korn" <dk at artimi dot com>
- To: "'Dave Cleal'" <dave at cleal dot com>,<gdb at sources dot redhat dot com>
- Date: Fri, 22 Oct 2004 16:00:33 +0100
- Subject: RE: Can't talk to Angel debug monitor from arm-elf-gdb
> -----Original Message-----
> From: gdb-owner On Behalf Of Dave Cleal
> Sent: 22 October 2004 15:47
> I've got an ATMEL EB40A ARM evaluation board that has ARM Angel 1.04
> running in the flash, and I can talk to this fine from the
> ARM-supplied AXD debugger. But I can't talk to it from arm-elf-gdb (I
> have v.6.1, compiled by macgraigor.com) which is running under cygwin
> on Windows 2000. arm-elf-gdb works just fine with the simulator
> target.
>
> I start up arm-elf-gdb, then do
>
> set remotebaud 9600
> target rdi com1
>
> The second command just hangs, I can see LEDs flashing to indicate
> that data is passing back and forth, but no response in gdb.
>
> Any ideas?
Not a great many. Not a target I'm familiar with, nor the supplier. But "set
debug remote 1" should allow you to see what's actually going back and forth,
which might give some clues...
cheers,
DaveK
--
Can't think of a witty .sigline today....