This is the mail archive of the
gdb@sourceware.org
mailing list for the GDB project.
RE: Breakpoint limit reached
- From: "Fahd Abidi" <fabidi at ultsol dot com>
- To: "Shaun Jackman" <sjackman at gmail dot com>,"Abatron Support" <support at abatron dot ch>
- Cc: <gdb at sources dot redhat dot com>
- Date: Wed, 3 Aug 2005 17:01:36 -0400
- Subject: RE: Breakpoint limit reached
The BDI understands to set SoftBreak points and hardware breakpoints
using the break and hbreak command in GDB. There should be no issue that
I know of. Maybe Ruedi can tell us if there is any known issue.
Fahd
-----Original Message-----
From: Shaun Jackman [mailto:sjackman@gmail.com]
Sent: Wednesday, August 03, 2005 4:20 PM
To: Abatron Support; Ultimate Solutions Support
Cc: gdb@sources.redhat.com
Subject: Breakpoint limit reached
Hello,
I'm debugging an ARM7TDMI with the BDI2000 and arm-elf-gdb 6.3. I have
one breakpoint set, and when I try to step over a function call using
the gdb "next" command, setting the breakpoint fails:
# TARGET: breakpoint limit reached
GDB displays this error message:
Cannot insert breakpoint 0.
Error accessing memory address 0x20008f0: Unknown error 4294967295.
I have soft breakpoints enabled on the BDI (BREAKMODE SOFT 0xDFFFDFFF)
and I'm setting soft breakpoints using gdb. I don't understand why
there would be a limit on the number of breakpoints.
If I 'set debug remote 1' then the final two packets displayed by gdb
are...
Sending packet: $m20008f0,4#5d...Ack
Packet received: 021c3b1c
Sending packet: $Z0,20008f0,2#a4...Ack
Packet received: E03
Why did the soft breakpoint, Z0, command fail? What does the error
code E03 mean? Does the BDI2000 differentiate between the soft
breakpoint "break" command Z0 packet, and the hard breakpoint "hbreak"
command Z1 packet?
Thanks,
Shaun Jackman
Pathway Connectivity