This is the mail archive of the
gdb@sourceware.org
mailing list for the GDB project.
Re: How to build & run ARM gdb?
- From: Robert Trask <rt_trask at yahoo dot com>
- To: gdb at sources dot redhat dot com
- Date: Wed, 14 May 2008 07:38:57 -0700 (PDT)
- Subject: Re: How to build & run ARM gdb?
As a follow on, I rebuilt the native gdb from 6.8 sources thus:
# ./configure
# make
# make install
It correctly interprets the arm elf file debug information, i.e. it's able to find symbols in source files via the "list" command etc.
Why is the simple act of cross-targeting gdb destroying this capability?
R.
----- Original Message ----
From: Robert Trask <rt_trask@yahoo.com>
To: gdb@sources.redhat.com
Sent: Tuesday, May 13, 2008 7:08:22 PM
Subject: How to build & run ARM gdb?
Hello,
I am doing remote ARM system development cross hosted on a Redhat FC4 machine.
For building gdb I do the following:
# ./configure --target=arm-none-eabi
# make
The
resulting gdb seems to work ok vis-a-vis connecting to the target via
the remote protocol but it has problems interpreting the debug info in
the executable thus:
(gdb) list <symbol_name>
No line number known for <symbol_name>.
Apparently this gdb can't understand the elf file?
But, the gdb that came with the RH distribution, ( GNU gdb Red Hat Linux (6.3.0.0-1.21rh) DOES understand the elf file and correctly finds the <symbol_name> in the appropriate source file.
Of course, since it was configured for "i386-redhat-linux-gnu" it has no hope of properly interacting with the remote ARM target.
I have tried all manner of different configurations (all accepted by config.sub). I get the same result.
What is happening here and how do I fix it?
I have tried this with gdb 6.7.1 and 6.8. I am using Redhat Fedore Core 4.
R.