This is the mail archive of the
insight-prs@sourceware.org
mailing list for the Insight project.
Re: insight/317: Target selection problems
- From: kseitz at sources dot redhat dot com
- To: hepler at vlsi-concepts dot com, insight-prs at sources dot redhat dot com, keiths at redhat dot com, nobody at sources dot redhat dot com
- Date: 13 Jul 2007 17:18:38 -0000
- Subject: Re: insight/317: Target selection problems
- Reply-to: kseitz at sources dot redhat dot com, hepler at vlsi-concepts dot com, insight-prs at sources dot redhat dot com, keiths at redhat dot com, nobody at sources dot redhat dot com, insight-gnats at sources dot redhat dot com
Synopsis: Target selection problems
Responsible-Changed-From-To: unassigned->keiths
Responsible-Changed-By: kseitz
Responsible-Changed-When: Fri Jul 13 17:18:38 2007
Responsible-Changed-Why:
mine
State-Changed-From-To: open->analyzed
State-Changed-By: kseitz
State-Changed-When: Fri Jul 13 17:18:38 2007
State-Changed-Why:
I'm not too sure why you got that error, but it wouldn't surprise me if there was some bitrot in this area. I don't do much embedded work anymore. The preference gdb/load/$target-portname is set in various places in targetselection.itb. It looks like the preference "default-portname" is not set, though. You might try adding something to pref_set_defaults in prefs.tcl to see if that mitigates anything.
You are correct: in order for you to add your target to the target selection dialog, you must add a little database entry for it. It is unfortunate, but that's all we have until gdb provides something better.
http://sourceware.org/cgi-bin/gnatsweb.pl?cmd=view%20audit-trail&database=insight&pr=317