This is the mail archive of the
insight@sources.redhat.com
mailing list for the Insight project.
[FWD] Stdout and stdin do not appear to run when running Insightan d Cygwin for the PowerPC.
- From: Keith Seitz <keiths at redhat dot com>
- To: "insight at sources dot redhat dot com" <insight at sources dot redhat dot com>
- Date: 05 Feb 2004 16:42:46 -0800
- Subject: [FWD] Stdout and stdin do not appear to run when running Insightan d Cygwin for the PowerPC.
- Organization:
-----Forwarded Message-----
> From: "Dickinson, Derek" <Derek.Dickinson@icn.siemens.com>
> To: 'Keiths@redhat.com' <Keiths@redhat.com>
> Subject: FW: Stdout and stdin do not appear to run when running Insight an d Cygwin for the PowerPC.
> Date: 05 Feb 2004 15:43:29 -0800
>
> Sorry about sending this directly to you, it was rejected at the following
> locations:
>
> insight-prs@sources.redhat.com
> insight-gnat@sources.redhat.com
> insight@sources.redhat.com
>
> I can't seem to send this into the mailing list. Where should this Email be
> addressed?
> Thanks,
> Derek
>
> PS. Of couse, any advice on the problem below would be great as well.
>
> > -----Original Message-----
> > From: Dickinson, Derek
> > Sent: Thursday, February 05, 2004 6:24 PM
> > To: 'insight-prs@sources.redhat.com'
> > Subject: Stdout and stdin do not appear to run when running Insight
> > and Cygwin for the PowerPC.
> >
> > The particulars:
> >
> > The test case is to build and execute a "hello world" program. Under some
> > circumstances this works and others it does not.
> >
> > Here are the environment details:
> >
> > Older MIPS Cross-Compiler Environment under Cygwin (compiled for
> > simulator). Works - Output appears in the Console Window of Insight.
> >
> > New cross compiler environment (target is defined to be "powerpc-eabi"):
> >
> > Binutils 2.14
> > Newlib 1.11.0
> > Gcc 3.3.2
> > Gdb 6.0
> > Insight 6.0
> >
> > Works on Solaris , However output appears in the originating terminal
> > window.
> >
> > Works on Cygwin using PowerPc simulator (using XXXX-run command).
> > Works on Cygwin using PowerPc XXXX-gdb (target sim, load, run).
> >
> > Fails under Cygwin using Insight. There are no error messages, the output
> > doesn't show up anywhere (console or originating terminal).
> > I've observed the same behavior with a PowerPc environment I built and one
> > supplied by MicroCross.
> >
> > Obviously, there is a bit of a grey area concerning whether the problem is
> > Insight or Cygwin since both of these are required for the failure case.
> >
> > I am going to dig into the source a bit to see what I can find. Of couse,
> > any pointers would be appreciated.
> >
> > Thanks in advance,
> > Derek
> >
> >
> >